?unique=c00fcff)
.webp?unique=18732d0)
.webp?unique=7f0ef7a)
.webp?unique=7f0ef7a)
?unique=c00fcff)
.webp?unique=18732d0)
.webp?unique=7f0ef7a)
.webp?unique=7f0ef7a)
Variations made for LOC, PML, ESTES and Balsa Machining Nose Cones.
**Fit may require sanding of nose cone and or printed sleeve to achieve desired fit due to variations in Nose Cones.
Additional Sleeves are available so you can swap one sled between multiple rockets!
Designed to be glues in or screwed in. (The smaller nose cones do better with glue)
In order to screw it in you will need to source 2-56 screws and drill the required holes (typ 1/16in)
Glueing in is as simple as it sounds, add a little epoxy to the nose cone and slide it in. Be sure not to get epoxy on the threads.
Sled base has 2 pass through holes to run wires from boards into the tube
Sled base has location for 1/4-20 nut to slide in and a 1/4-20 Eye-bolt to be run through for shock cord mounting.
**The 2.6in & 4in sleds are interchangable between LOC and PML sleeves, the sleeve distinctions are being made to increase performance of the parts while in use.
The Sled can handle trackers or Dual Deploy Electronis.
Max Board Length x Width: (per side)
1.9in: 3.6in x 1.15in
54mm: 4in x 1.2in
2.6in: 3.5in x 1.6in
3in: 4in x 2.2in
4in: 5in x 2.7in
5.38: 5in x 4in
7.5: 6in x 6in
Sleeve Diameters:
1.9in: 1.68in
54mm: 1.95in
2.6in LOC: 2.41in
2.6in PML: 2.38in
3in LOC: 2.86in
3in EST: 2.8in
4in PML: 3.7in
4in LOC: 3.75in***
5.38in: 5.18in
7.5in: 7.29in
***Fits Fiberglass Coupler of that size
Includes:
1 - Threaded Sleeve (Note this does have a top and a bottom, it only threads in one way)
1 - Threaded Electronics Carrier/Bulkhead
Still Needed (1.9-4in)
1 - 1/4-20 Eye Bolt
1 - 1/4-20 Nut
Still Needed (5.38)
1 - 3/8-16 Eye Bolt
1 - 3/8-16 Nut
1 - 1/2 Washer (reccomended)
Still Needed (7.5)
1 - 1/2 Eye Bolt
1 - 1/2 Nut
1 - 1/2 Washer
Retention Method to Nose Cone (Glue or screws)
Vidoe showing use of system: https://youtu.be/IV6kjvcf1Iw